Knowledge Base - How To:- Fit Wheel Spacers.

My first attempt at a how to!
Right today I finaly fitted my 10mm rear spacers with longer studs done in 2 hours, first side took a lot longer! once I knew what to do the other side took no time at all! 

Tools needed:

Trolley or bottle jack
Axle stands
17 socket
12 socket
Hammer
Long metal bar or spare breaker bar
M12 washers
large socket
Appropriate socket for your nuts (if not already listed)

Do this on level ground, loosen the wheel nuts then release the handbrake.


Image
Jack up on the middle of the cross member

Image
Support with axle stands and slowly release the pressure on the jack and let them take the weight.

Image
Take out the loosened wheel nuts and take off the wheel.

Image
Spray 1 and 2 and the bolt above 2 with W40 just to make things easier. Undo and remove 1(12mm) and pivot the caliper and remove the brake pads. Then remove 2 and the same one that is at the other end of the caliper (17mm).

Image
Using a tie wrap suspend the caliper from the spring to keep it out of the way and to prevent any stress on the brake pipe.

Image
The litle recess you can see is where the stud comes out of, at this point you want to knock off the brake disc block of wood between the hammer and disc works if you dont have a rubber mallet.

Image
You knock the old stud out with a hammer and slide the new one into place through the recess, put on some washers and I used an over sized socket to pack it out further and using an old MR2 wheel nut the type with a washer used it to pull the new studs on and into place.

Image
Forgot to show it in place but I used the bar slid between two studs and resting on the floor to prevent the hub from turning as you tighten the stud to pull it on.

Image
Refit in reverse sliding the spacer on at the end. Put a bit of thread lock on the bolts prior to putting back to together.
Refit your wheels remove the axle stands and jack stand back and admire!!!!

Craig LLEWELLYN

Copyright © by MR2 Owners Club All Right Reserved.

Details

Created : 2011-06-13 19:49:21, Last Modified : 2011-06-13 19:49:21

Technical Disclaimer 

The MR2 Owners Club and its respective owners, editors and contributors make no representations about the suitability of the information contained in the documents, materials and related graphics published on mr2oc.co.uk  

By using this site, you hold the site and it's affiliates not legally responsible for any damages due to advice given here. This site and it's affiliates takes no responsibility for consequences of any actions that arise from advice given. Any opinion is given with information provided by you and can not be taken as absolute.

All repairs should be undertaken by a competent and qualified technician. By using this site, you understand and agree that all advice given and followed are at your own risk and do not hold this site or it's affiliates responsible for any damages.