How to - Convert The Stock Boost Gauge To A Stock Voltmeter
-
Topic author - Posts: 4966
- Joined: 20/03/08 11:45
- Years of MR2 Ownership: 10
- MR2's Owned: 7
- Real Name: Jay
- Gender: Male
- Location: Northampton
- Been thanked: 8 times
Re: How to - Convert The Stock Boost Gauge To A Stock Voltme
Bump for Jimi
Sent from my HTC One X using Tapatalk 4
Sent from my HTC One X using Tapatalk 4
1993 Revision 3 Turbo - Restoration Underway
-
- Posts: 3
- Joined: 11/08/21 3:00
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Does anyone have a better close up pic of this mod done (either the solder or the wire with eyelets (my preference)
-
- Administrator
- Posts: 5196
- Joined: 17/05/04 1:00
- Years of MR2 Ownership: 18
- MR2's Owned: 1
- Gender: Male
- Location: Glenrothes: The Kingdom of Fife
- Has thanked: 45 times
- Been thanked: 118 times
- Contact:
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Seems straightforward,
Picture shows the PIM board reinstalled with two screws (this is after the link has been soldered in on the board) if your doing it with a crimped link it goes between the 2 screws shown in the picture, the other 2 screws are left out.
Picture shows the PIM board reinstalled with two screws (this is after the link has been soldered in on the board) if your doing it with a crimped link it goes between the 2 screws shown in the picture, the other 2 screws are left out.
-
- Posts: 3
- Joined: 11/08/21 3:00
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
I was more hoping to see the jump wire, but I think I have it.
-
- Posts: 3
- Joined: 11/08/21 3:00
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Also, you can remove the PIM board if you use the jumper wire with eyelets?