Wheel fitment
-
Topic author - Posts: 13
- Joined: 23/06/18 8:59
- Years of MR2 Ownership: 0
- MR2's Owned: 1
- Real Name: Jason
- Gender: Male
- Location: Sheffield
Wheel fitment
I’ve had a search through previous posts in here and can’t seem to find the information I’m after.
I’m currently looking at buying some new wheels, I was wondering if anyone on here could tell me how the MK2 reacts with a square wheel setup, instead of the standard staggered setup.
Thanks
I’m currently looking at buying some new wheels, I was wondering if anyone on here could tell me how the MK2 reacts with a square wheel setup, instead of the standard staggered setup.
Thanks
-
- Full Member
- Posts: 5435
- Joined: 29/07/06 1:00
- Current Model: None
- Years of MR2 Ownership: 16
- MR2's Owned: 6
- Real Name: Three guesses!
- Gender: Male
- Location: Kent
- Been thanked: 31 times
Re: Wheel fitment
I would expect the ride to be extremely uncomfortable.Jason20 wrote: ↑09/03/19 12:31 I’ve had a search through previous posts in here and can’t seem to find the information I’m after.
I’m currently looking at buying some new wheels, I was wondering if anyone on here could tell me how the MK2 reacts with a square wheel setup, instead of the standard staggered setup.
Thanks
You don't mention whether you have a Mk1, Mk2, or Mk3.
I can only comment on the Mk2.
My first one had 17 x 7Js all round with lowered springs.
The rear tyres were staggered though, 20mm wider than the front.
Not having anything to compare it with at the time, it was difficult to pass judgement.
After switching to a staggered set I can say the original configuration was more 'twitchy'.
Particularly if provoked (which of course shouldn't be happening on the road).
You could always restore the differential in the track width by using spacers on the rear.
Personally I'm not a fan of them as its a compromise engineering solution.
See item 4 in this vid -
If you're not living life on the edge, you're taking up too much room!
HM wrote: TonyleFrog aka "The Fog Penetrator"
HM wrote: TonyleFrog aka "The Fog Penetrator"
-
- Administrator
- Posts: 5166
- Joined: 17/05/04 1:00
- Years of MR2 Ownership: 18
- MR2's Owned: 1
- Gender: Male
- Location: Glenrothes: The Kingdom of Fife
- Has thanked: 45 times
- Been thanked: 116 times
- Contact:
Re: Wheel fitment
TonyleFrog wrote: ↑09/03/19 19:34I would expect the ride to be extremely uncomfortable.Jason20 wrote: ↑09/03/19 12:31 I’ve had a search through previous posts in here and can’t seem to find the information I’m after.
I’m currently looking at buying some new wheels, I was wondering if anyone on here could tell me how the MK2 reacts with a square wheel setup, instead of the standard staggered setup.
Thanks
You don't mention whether you have a Mk1, Mk2, or Mk3.
I can only comment on the Mk2.
Should have gone to specsavers Tony
I’m currently looking at buying some new wheels, I was wondering if anyone on here could tell me how the MK2 reacts with a square wheel setup, instead of the standard staggered setup.
-
- Full Member
- Posts: 5435
- Joined: 29/07/06 1:00
- Current Model: None
- Years of MR2 Ownership: 16
- MR2's Owned: 6
- Real Name: Three guesses!
- Gender: Male
- Location: Kent
- Been thanked: 31 times
Re: Wheel fitment
In my defence, your vision would be blurred too if you had consumed the same amount of Merlot...
If you're not living life on the edge, you're taking up too much room!
HM wrote: TonyleFrog aka "The Fog Penetrator"
HM wrote: TonyleFrog aka "The Fog Penetrator"
-
- Administrator
- Posts: 5166
- Joined: 17/05/04 1:00
- Years of MR2 Ownership: 18
- MR2's Owned: 1
- Gender: Male
- Location: Glenrothes: The Kingdom of Fife
- Has thanked: 45 times
- Been thanked: 116 times
- Contact:
-
- Posts: 2683
- Joined: 13/08/07 13:06
- Years of MR2 Ownership: 12
- MR2's Owned: 2
- Real Name: Pete
- Gender: Male
- Location: Stratford upon Avon
- Has thanked: 2 times
- Been thanked: 11 times
Re: Wheel fitment
I have had 17" x 7J rims and 17" x 7.5j and currently staggered 17" x 8j fr/ 9j rear.
215/40 and 235 /40 on both 1st sets.
215/40 and 245/40 on staggered wheels.
you should always try and keep rears 20mm wider than fronts, used bolt on hubcentric spacers on 1st 2 sets with no issues apart from last time had to cut the spacer off as the bolt rounded.
I also know a couple who have run same width tyres all round with no real adverse issues on the road.
the most sure footed is definitely the staggered setup on wheels and tyres.
my advice is
1) go with staggered wheel / staggered tye set up
2) if no staggered wheels, 215/40/17 fronts and 235/40/17 rears and space the rears out by 15mm
215/40 and 235 /40 on both 1st sets.
215/40 and 245/40 on staggered wheels.
you should always try and keep rears 20mm wider than fronts, used bolt on hubcentric spacers on 1st 2 sets with no issues apart from last time had to cut the spacer off as the bolt rounded.
I also know a couple who have run same width tyres all round with no real adverse issues on the road.
the most sure footed is definitely the staggered setup on wheels and tyres.
my advice is
1) go with staggered wheel / staggered tye set up
2) if no staggered wheels, 215/40/17 fronts and 235/40/17 rears and space the rears out by 15mm
Highland Drive 13/14/15/17/18/19
JAE 07/09/10/11/12/13/14/15/16/17
Japfest 09/11/12/13/16/19
Wales runs 14/15/16/17/18
-
- Posts: 4507
- Joined: 07/05/06 1:00
- Years of MR2 Ownership: 12
- MR2's Owned: 6
- Real Name: Mark
- Gender: Male
- Location: Reading, UK
- Been thanked: 2 times
- Contact:
Re: Wheel fitment
This is spot on
I've run both square and staggered setups. If you put quality 15mm spacers on the rear and stagger the tyres, then the fact the setup is square fades away as a factor compared to the quality of your tyres and the geometry setup. The difference with and without the rear spacers is noticeable.
This is one of my recent setups; 16x7.5J all round with 205/45/16 front and 225/45/16 rear:
You can see a slight difference in the way the sidewalls sit, but the AD08Rs made sure it handled great!
My caution would be to avoid running 235/40/17 on 7Js - it will visibly bulge and I'm not sure how great they're handle. When I was running 17x7J all round, I had 205 front and 215 rear, which also isn't ideal. It's hard to figure out a good tyre setup for 17x7J all-round
-
- Full Member
- Posts: 5435
- Joined: 29/07/06 1:00
- Current Model: None
- Years of MR2 Ownership: 16
- MR2's Owned: 6
- Real Name: Three guesses!
- Gender: Male
- Location: Kent
- Been thanked: 31 times
Re: Wheel fitment
The best combo would be 205/40/17 front and 225/40/17 rear.shinny wrote: ↑10/03/19 1:50 My caution would be to avoid running 235/40/17 on 7Js - it will visibly bulge and I'm not sure how great they're handle. When I was running 17x7J all round, I had 205 front and 215 rear, which also isn't ideal. It's hard to figure out a good tyre setup for 17x7J all-round
https://www.tyres-pneus-online.co.uk/ty ... dvice.html
No problem with the front but try getting those for the rear. I had to settle for 215 & 235.
Yes, the latter weren't ideal (see my earlier post) but I didn't have much choice at the time.
Your alternative of 16" rims and 45 section tyres on 7.5Js makes perfect sense.
One point which hasn't been mentioned so far is offset.
ISTR oddshoes had a set of staggered 16" AVS on offer a while back.
Not sure whether they were snapped up.
If you're not living life on the edge, you're taking up too much room!
HM wrote: TonyleFrog aka "The Fog Penetrator"
HM wrote: TonyleFrog aka "The Fog Penetrator"
-
Topic author - Posts: 13
- Joined: 23/06/18 8:59
- Years of MR2 Ownership: 0
- MR2's Owned: 1
- Real Name: Jason
- Gender: Male
- Location: Sheffield
Re: Wheel fitment
Thanks guys!
The wheels I’m looking at are Enkei evo 9 wheels which I think are 17 x 8 +35. So I’d imagine a 215 on the front and a 235 on the rear would be okay with spacers on the rear?
The wheels I’m looking at are Enkei evo 9 wheels which I think are 17 x 8 +35. So I’d imagine a 215 on the front and a 235 on the rear would be okay with spacers on the rear?
-
- Posts: 4507
- Joined: 07/05/06 1:00
- Years of MR2 Ownership: 12
- MR2's Owned: 6
- Real Name: Mark
- Gender: Male
- Location: Reading, UK
- Been thanked: 2 times
- Contact:
-
Topic author - Posts: 13
- Joined: 23/06/18 8:59
- Years of MR2 Ownership: 0
- MR2's Owned: 1
- Real Name: Jason
- Gender: Male
- Location: Sheffield
-
- Full Member
- Posts: 5435
- Joined: 29/07/06 1:00
- Current Model: None
- Years of MR2 Ownership: 16
- MR2's Owned: 6
- Real Name: Three guesses!
- Gender: Male
- Location: Kent
- Been thanked: 31 times
Re: Wheel fitment
JFI, I'm pretty sure stock Mitsi Evo 9 wheels are ET38.
If you're not living life on the edge, you're taking up too much room!
HM wrote: TonyleFrog aka "The Fog Penetrator"
HM wrote: TonyleFrog aka "The Fog Penetrator"