Re: How to - Convert The Stock Boost Gauge To A Stock Voltme
Posted: 16/08/13 15:05
Bump for Jimi 
Sent from my HTC One X using Tapatalk 4
Sent from my HTC One X using Tapatalk 4
MR2 Owners Club
MR2 Owners Club
https://mr2oc.co.uk/forums/
How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Page 2 of 2
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Posted: 11/08/21 3:05
Does anyone have a better close up pic of this mod done (either the solder or the wire with eyelets (my preference)
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Posted: 16/08/21 22:47
Seems straightforward,
Picture shows the PIM board reinstalled with two screws (this is after the link has been soldered in on the board) if your doing it with a crimped link it goes between the 2 screws shown in the picture, the other 2 screws are left out.
Picture shows the PIM board reinstalled with two screws (this is after the link has been soldered in on the board) if your doing it with a crimped link it goes between the 2 screws shown in the picture, the other 2 screws are left out.
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Posted: 16/08/21 23:00
I was more hoping to see the jump wire, but I think I have it.
Re: How to - Convert The Stock Boost Gauge To A Stock Voltmeter
Posted: 16/08/21 23:01
Also, you can remove the PIM board if you use the jumper wire with eyelets?