Knowledge Base - Info:- Fitting a T-piece for a Oil Pressure Gauge

Thanks to NoddE for this information

If your going to put a T-piece where the stock oil pressure sensor is, make sure you get a T that has 1/8 BSPT. the stock sensor uses that thread.

The T should have one male BSPT (British Standard Pipe [thread] Tapered), one female BSPT and then for the aftermarket sensor a female NPT (National Pipe [thread] Tapered.


Copyright © by MR2 Owners Club All Right Reserved.


Created : 2011-10-05 15:30:00, Last Modified : 2011-10-05 15:30:00

Technical Disclaimer 

The MR2 Owners Club and its respective owners, editors and contributors make no representations about the suitability of the information contained in the documents, materials and related graphics published on  

By using this site, you hold the site and it's affiliates not legally responsible for any damages due to advice given here. This site and it's affiliates takes no responsibility for consequences of any actions that arise from advice given. Any opinion is given with information provided by you and can not be taken as absolute.

All repairs should be undertaken by a competent and qualified technician. By using this site, you understand and agree that all advice given and followed are at your own risk and do not hold this site or it's affiliates responsible for any damages.