Welcome to Know Your 2
A repository of knowledge for all things MR2 related

How To:- Replace a Rear Light Bulb

Star InactiveStar InactiveStar InactiveStar InactiveStar Inactive

Bulb replacement necessitates removal of the rear lamp units as access via the boot area is not possible.

Firstly remove the amber corner unit. Look carefully for the gap between the corner and the main lamp unit. Using a flat bladed screwdriver wrapped with tape to prevent damage, carefully prize the corner unit until the spring catch pops free. Underneath you will find 2 cross headed screws that need to be removed.

The lamp unit is now held by several strong friction clips. To allow a firm grip that is even on both sides of the lamp unit, remove the centre panel by undoing the 4 nuts located inside the boot area (you will need to pull the boot lining forward to access these bolts) and removing the 2 black screws at either end of the centre panel. You can now exert sufficient force to safely disengage the friction clips.

To change the reverse lamp bulbs on Revision 3 onwards models, you need only unbolt the centre panel.


Peter Jones

Copyright © by MR2 Owners Club All Right Reserved.

Print Email

Technical Disclaimer 

The MR2 Owners Club and its respective owners, editors and contributors make no representations about the suitability of the information contained in the documents, materials and related graphics published on mr2oc.co.uk  

By using this site, you hold the site and it's affiliates not legally responsible for any damages due to advice given here. This site and it's affiliates takes no responsibility for consequences of any actions that arise from advice given. Any opinion is given with information provided by you and can not be taken as absolute.

All repairs should be undertaken by a competent and qualified technician. By using this site, you understand and agree that all advice given and followed are at your own risk and do not hold this site or it's affiliates responsible for any damages.